QMark QFG1512T2M Electric Fan-Forced Wall Heater - CLEARANCE

Key Features

• RESIDENTIAL: The QMark QFG1512T2M electric in-wall heater is suitable for use in almost any room. Use single heaters in smaller rooms such as bedrooms and bathrooms. Use multiple heaters (controlled by a single thermostat - sold separately) in larger rooms such as living rooms and family rooms. Wattage should be determined through heat loss calculations.
• COMMERCIAL: Suitable as the primary heat source in smaller rooms and as supplemental heat in almost any general use area.
  
• Dual Protection: Thermal cutout with indicator light and one time thermal fuse.
• Tangential blower for whisper quiet operation.
• Sienna White baked enamel finish.
• Open coil element assures quick heat and low maintenance.
• Three piece construction for ease of installation.
• Permanently lubricated, dust protected bearings.
• CLIP-N-FIT® FEATURE Patented Clip-N-Fit® feature (US Patented No. 6,172,343) allows the installer to change the wattage of the heater to a lower output without moving jumper wire. Each heater is factory wired for its maximum wattage. To change wattage, clip out either jumper 1 or 2 as shown in the installation manual for desired wattage. This Patented Clip-N-Fit® feature also prevents the operator to change wattage after installation to a higher wattage.

VOLTS                   CFM                 PHASE               WATTAGE                    UNIT AMPS
120                           45                       1                       1500/1125                    12.5/9.4
                                                                                      750/375                        6.3/3.1